Sensing method: Diffuse reflective.
Appearance: Vertical.
Connection method: Pre-wired .
Sensing distance: 30 to 50 mm.
Model: NPN Voltage output type E5EN-HAA2HBMD-W-500 PDF.
Both Red-light Models and Green,
light Models to Detect a Wide Variety,
of Colors. Appearance: Unshielded.
Sensing surface: Top.
Sensing distance: 1.6 mm.
Model: Operation mode, NC.
Advanced Performance and Wide E5EN-HAA2HBMD-W-500
Range of Selections in a Super.
compact Size.
Only 5.5 × 5.5 mm with a built-in Amplifier.
Maximum sensing distance: 2.5 mm. Stable detection even with,
workpiece fluctuations.
Response frequency: 1 kHz.
Low current consumption E5EN-HAA2HBMD-W-500 PDF. Type: Standard models.
Connecting method: Wire-saving connector *1.
Model: PNP output.
Applicable wire-saving connector(sold separately):
Type,Master connector, Slave connector; Model, E3X-CN21, E3X-CN22.
Stable Detection with Advanced Fiber.
Amplifier Units.
A wide range of added value with standard models with one,
input and two outputs, and ultra-long-term APC models with an,
APC life of approximately 20 years E5EN-HAA2HBMD-W-500 PDF.
Power turning to easily set the optimum light level.
Automatic Power Control (APC) is always enabled to stabilize,
emitter power with high accuracy OMRON INSTRUCTION Manual.
GIGA RAY for stable detection with the highest level of power in,
this class even for low-reflective objects and large objects.
The E3X-DA0-S supports an EtherCAT Sensor Communications,
Unit or CompoNet Sensor Coommunications Unit E5EN-HAA2HBMD-W-500 Manual.
Size: 48 x 96mm.
Type: power AC/DC24V with OMRON INSTRUCTION Manual.
Shell color: black.
Control output 1: output unit mode.
Control output 2: output unit mode.
Control mode: standard or heating cooling.
Auxiliary output points: 2 points.
Heater break, SSR fault detection function: single phase or three phase heater detection function.
Event entry point: 2.
Transfer output: - OMRON INSTRUCTION Manual.
Remote SP:4 to 20mA input.
Communication: RS-422.
New program type.
A new type of liquid crystal with high performance cost ratio is adopted in the 256 paragraph,
Visual angle, contrast can be improved.
Can be set up to 8 procedures (mode) x 32 (step) procedure.
High resolution 5 bit display / can display 0.01 degrees C.
High speed sampling period 60ms.
All models complete a variety of (to the thermocouple /Pt/ analog input switching), 1 machines to support a variety of sensors.
Also supports remote SP.
Add PV/SV state display function, to see the state of the thermostat
(automatic / manual, RUN/RESET, alarm), interactive display PV/SV.
Through the support software (Ver.4.3 CX-Thermo) makes thhe process of setting management becomes very
Simple use of simple computing functions (AND/OR logic and delay) to set the implementation of flexible contact output E5EN-HAA2HBMD-W-500 INSTRUCTION Manual.
Through the infrared port can be carried out from the frront of the communication E5EN-HAA2HBMD-W-500 Manual.
The control output ON/OFF times counting function can predict the fault of the internal relay of the temperature controller.