Appearance: M4.
Sensing distance: 0.8 mm.
Connecting method: Pre-wired Models (2 m).
Cable specifications: PVC(oil-resistant).
Operation mode: NC E3C-LR15 PDF.
Wire color /pin arrangement: Brown: +V, Black: Output, Blue: 0 V.
Model: NPN output.
Ultra small size, but surprisingly easy installation!
With the addition of M4, 5.4-dia., 6.5-dia. size, unshielded,
pre-wired connector model, and connector model, a total of,
108 model variations are available E3C-LR15
High-speed response frequency stably detects moving,
objects: 5 kHz max.
Four indicator lamps for easier indicator positioning.
Special mounting brackets reduce time and efforts for,
installation E3C-LR15 PDF.
Protective Stainless-steel Spiral Tube against wire,
breakage is available (M4, M5 only).
Models also available with standard cables that are 5 m long,
or with robot (bending-resistant) cables. E32-T61-S type: environment resistant; heat resistant,
Specialty: heat resistant: 350,
Shape / detection distance (mm): 600; 450; 300 (120),
Bending radius (mm): R25 E3C-LR15 PDF.
Standard test object (minimum test object) (mm) 1: 1 (0.005),
Fiber element for meeting diversified needsSize: 96 x 96mm.
Category: power AC100 ~ 240V with.
Shell color: black OMRON INSTRUCTION sheet E3C-LR15 Manual.
Control output 1: position ratio with relay output.
Control output 2: position ratio with relay output.
Control mode: standard or heating cooling.
Auxiliary output points: 2 points.
Heater break, SSR fault detection function: single phase or three phase heater detection function.
Event entry point: 2 OMRON INSTRUCTION sheet.
Transfer output: transfer output (special terminal).
Remote SP:4 to 20mA input.
Communication: RS-232C.
New program type.
A new type of liquid crystal with high performance cost ratio is adopted in the 256 paragraph,
Visual angle, contrast can be improved.
Can be set up to 8 procedures (mode) x 32 (step) procedure OMRON INSTRUCTION sheet.
High resolution 5 bit display / can display 0.01 degrees C.
High speed sampling period 60ms.
All models complete a variety of (to the thermocouple /Pt/ analog input switching), 1 machines to support a variety of sensors.
Also supports remote SP.
Add PV/SV state display function, to see the state of the thermostat
(automatic / manual, RUN/RESET, alarm), interactive display PV/SV.
Through the support software (Ver.4.3 CX-Thermmo) makes the process of setting management becomes very
Simple use of simple computing functions (AND/OR logic and delay) to set the implementation of flexible contact output E3C-LR15 INSTRUCTION sheet.
Through the infrared port can be carried out from the frront of the communication E3C-LR15 Manual.
The control output ON/OFF times counting function can predict the fault of the internal relay of the temperature controller.