Name: e-CON Connectors.
Specifications: Outputs; 32 outputs; PNP;
Without Short-circuit and,
Disconnected Line Detection.
"Easy" and "Flexible" system expansion,
with linked CC-Link and CompoNet CRT1-ID16 PDF.
Branching is easily made with CompoNet.
Wiring material cost can be reduced.
Bit-level I/O distribution reduces,
wiring in the system.
A wide variety of CompoNet Slave Units,
contribute to system size reduction CRT1-ID16
Seven-segment Display on the Gateway Unit,
helps to detect errors on site.
The Participation Flags and Communications,
Error Flags can be checked at the Host,
Controller to detect the location and,
content of the error CRT1-ID16 PDF. Model : CVM1-PRS21-EV2.
For ladder.Model: C500-CE401.
Solder pin connector cover 40PC500-DA/3G2A5-DA Special I/O Unit Analog Output C500-DA003(3G2A5-DA003).
Output: 2 pts.
Specification: 0~+5V.Model: CPM2C-10EDR. Units with 10 I/O points.
1 I/O terminal block CRT1-ID16 PDF.
Inputs: 6 inputs.
Ouutputs: 4 outputs CRT1-ID16 Manual.
Input type: 24 VDC.
Output type: relay.Unit name: Loop Control Boards.
Specifications: No. of function blocks:
50 blocks max.
Standards: UC1, N, CE.
The open nature of the PLCs is joined,
by integrating hardware, software,
and networking to meet your needs OMRON Safety Precautions.
Increasing amounts of information,
standardization, and open standards,
form the basis for achieving hardware,
and networking capabilities for process control.
A wide range of software that can be easily,
used by design, development, and maintenance,
personnel makes operating and maintaining,
the system far easier OMRON Safety Precautions. Model: C200H-OC222.
No. of points: 12 pts.
Specifications: 2A, 250VAC/24VDC(For resistive loads).Unit type: CS1 CPU Bus Units.
Product Name: MECHATROLINK-II,
compatible Position Control Unit.
Specifications: Control commands,
executed by MECHATROLINK-II,
synchronous communications OMRON Safety Precautions.
Direct operation by ladder,
programming, Control mode:
Position control, speed control,
or torque control; No. of axes: 4.
No. of unit nummbers allocated: 1 CRT1-ID16 Safety Precautions.
Current consumption: 5V, 0.36A; 26V, --.
Standards: UC1, CE.
Decrease TCO with Simple Operation,
Reduced Wiring, Batch Settings,
and Batch Management.
Control Servos for up to 16 axes,
in a motion networkk with one Position,
Control Unit that supports MECHATROLINK-II CRT1-ID16 Manual.
MECHATROLINK-II is a registered trademark,
of the MECHATROLINK Members Association.