Compact flash memory card.
Capacity: 4GB bytes. RS232 connector conversion cable (round connector, 9 pin D-sub connector).
Easy connection through the hub CPU Q50UDEHCPU PDF.
By using an Ethernet hub, programming tools and multiple CPU can be connected simultaneously.
Through the programming tool can be searched and displayed in the list has been connected to the CPU.
Therefore, even if the IP CPU address is unknown, just choose from this list, you can easily connect Q50UDEHCPU
Seamless communication without network level constraints.
With the latest high-speed, large capacity IE CC-Link controller network and IE CC-Link field network,
Corresponding to the increasing amount of information Q50UDEHCPU PDF.
Together with previous MELSECNET/H, Ethernet and CC-Link,
These networks can be across the network type or level of differences, to achieve seamless communication.
Programmable logic controller on the network through the programming tool of the Ethernet connection,
Monitoring and programming Q50UDEHCPU PDF. Master station module supporting AnyWireASLINK system.
Connecting sensor and programmable controller.
Free configuration of sensors, conntrol of 512 points of the input and output Q50UDEHCPU Manual.
The AnyWireASLINK transmission line (2 lines) can be used for communication to supply power for the sensor, and the sensor can also be conveniently added MITSUBISHI Programming Manual.
Can through the project software GXWorks2 batch management sensor shedding detection and from the station module settings, etc.,
Substantial savings in time and cost.Input / output points: 4096 points MITSUBISHI Programming Manual.
Number of input and output elements: 8192.
Program capacity: 1000 K step.
Processing speed: 0.0095 s.
Program memory capacity: 4000 KB.
Support USB and network.
Support installed memory card.
Providing high speed communication between multiple CPU.
Shorten the fixed scan interrupt time, high precision device MITSUBISHI Programming Manual.
The minimum interval of the fixed period interrupt program is reduced to 100 s.
The high speed signal can be accurately obtained, which makes the contribution to the higher precision of the device.
High speed and high precision machine control by multi CPU.
By parallel processing of the linear and multi CPU high-sspeed communication (cycle 0 Q50UDEHCPU Programming Manual. 88ms) of the parallel control program, the high speed control.
Multi CPU high speed communication cycle and motion control synchronization, so it can achieve the maximization of computing efficiency.
Inn addition, the latest movement control CPU in performance is 2 times the previous model,
To ensure high speed and high accuracy of the machine control Q50UDEHCPU Manual.