"X 10BASE-T/100BASE-T 1 channel.
No need to use PC to meet all the recording needs of the high-speed data recorder module.
High speed, simple, low cost, the accuracy of data records beyond the past Q172CPU PDF.
Can be used to guide the form of a simple set of high speed data recorder module configuration tool",
And display the collected data with the trend chart,
Help to carry out data analysis, etc Q172CPU the recording data display / analysis tool "LogViewer GX"".
By accumulating all kinds of data in the production process,
Not only can help improve the quality of products, reduce production costs, but also for the optimization of the system,
Contribute to the construction of an efficient production site Q172CPU PDF. "SRAM+E2PROM memory card.
RAM capacity: 128KB.
E2PROM capacity: 128KB. "Maximum control axis: 4 axis.
Connection mode with servo amplifier: SSSCNET III /H connection type Q172CPU Manual.
The maximum distance between the drive units: 100m Q172CPU PDF.
Operation cycle: 0.88ms.
Interpolation function: linear interpolation (maximum 4 axis), 2 axis arc interpolation.
Color signal: 4 points.
Color detecting set: 4 set.
Even the long distance wiring can be flexible.
The use of fiber optic cable, with high speed, high performance, high reliability of the servo system controller network MITSUBISHI Programming Manual.
In addition to the traditional positioning control, but also to support speed / torque control and synchronous control.
Use simple movement module setup tool",
Can easily perform positioning settings, monitoring and debugging, etc..
In addition, the data can be collected and displayed synchronously with the motion controller MITSUBISHI Programming Manual.
SSCNET III /H connection to save the wiring, the maximum distance between the station up to 100m,
Absolute position system can be easily supported.
The upper limit limit switch, the lower limit switch and the near point block signal are input by the servo amplifier,
Thus greatly reducing wiring MIITSUBISHI Programming Manual Q172CPU Programming Manual.
In addition to positioning control and speed control, but also to perform synchronization control, cam control, torque control, touch pressure control, etc..
Positioning module (QD75MH) of the project annd the sequence of the previous model is highly compatible with the old model,
The project can be easily applied to the simple motion module (QD77MS) Q172CPU Manual. "