Input / output points: 4096 points.
Number of input and output elements: 8192.
Program capacity: 26 K step.
Processing speed: 79ns.
Program memory capacity: 144 KB Q00JCPU-S8-SET PDF.
Built in RS232 communication port.
Support installed memory card.
For A mode only.
Enhance the basic performance.
CPU''s built-in soft element memory capacity increases to up to 60K.
To increase the control, quality management data can also be processed at high speed Q00JCPU-S8-SET
Convenient processing of large capacity data.
In the past can not achieve the standard RAM and SRAM card file register area of continuous access,
The boundary of each area should be considered in programming Q00JCPU-S8-SET PDF.
The SRAM 8MB extension card is installed in the high speed universal QCPU,
Standard RAM can be used as a continuous file register,
Capacity up to 4736K words, thus simplifying the programming.
Thus, even if the memory space of the soft element is insufficient,
Can also be installed by the expansion of SRAM card, easy to extend the file register area Q00JCCPU-S8-SET PDF Q00JCPU-S8-SET Manual .
The address register is extended to 32 bits, which can be programmed to go beyond the traditional 32K word,
And to achieve the extension to the file register to all regions of the file register.
In addition, the processing speed of the index modification plays an important role in the efficient operation of structured data (array),
The speed has been improved MITSUBISHI PROGRAMMING Guide Book.
When the index is used to modify the program repeatedly (e.g. from FOR to NEXT), the scan time can be reduced.SRAM+E2PROM memory card MITSUBISHI PROGRAMMING Guide Book.
RAM capacity: 128KB.
E2PROM capacity: 128KB. Redundant CPU data tracking cable length of 1 meters.
Can only be used for MITSUBISHI Q series PLC redundancy CPU.Input and output points: 1024 points.
Input / output data points: 8192 points.
Program capacity: 60k.
Basic command processing speed (LD command) S:0 MITSUBISHI PROGRAMMING Guide Book. 2.
PLC in the program execution stage: according to the order of the user program order to store the order of each instruction,
After the corresponding operation and processing, the result is writtten to the output status register,
The contents of the output status register are changed with the execution of the program Q00JCPU-S8-SET PROGRAMMING Guide Book.
Output refresh phase: when all instructions are executed,
The output status register is sent to the ooutput latch in the output refresh stage,
And through a certain way (relay, transistor or transistor) output, drive the corresponding output equipment Q00JCPU-S8-SET Manual .