Cable length: 2m.
For MR-J2S-700A (4) /CP/CL or less.
Encoder for HC-SFS; HC-LFS; HC-RFS; 2000r/min HA-LFS; HC-UFS servo motor.
-H products have a long flex life MR-J3-200B PDF. Drive unit.
MITSUBISHI universal AC servo amplifier MELSERVO-J4 series.
Rated output: 55kw.
Interface: SSCNET III /H.
Power supply: three phase AC400V.
Support position control, speed control, torque control.
Position control to follow the position instructions MR-J3-200B
When the control is inserted, the position control is performed.
Speed control follows the speed command to control the speed within a certain range.
Torque control to follow the torque command to control the stable torque MR-J3-200B PDF.
Function of switching amplitude. The increase in the process of switching and stopping,
And in the operation of the use of the switching signal, switching growth. Drive: MR-H_ACN series SSC-NET compatible AC servo.
Rated output: 0.6KW.
The servo controller can easily transfer the operation module and the field bus module through the automation interface,
At the same time using different fieldbus modules to achieve different control modes (RS485, RS232, optical fiber, InterBus, ProfiBus),
And the control mode of general inverter is single MR-J3-200B PDF.
The servo controller is directly connected with a rotary transformer or an encoder, which forms a closed loop of speed and displacement control MITSUBISHI INSTRUCTION MANUAL.
The general inverter can only form an open loop control system.
Servo ccontroller of the control parameters (such as steady-state accuracy and dynamic performance) is better than the general inverter MITSUBISHI INSTRUCTION MANUAL MR-J3-200B Manual. MITSUBISHI motor universal AC servo amplifier MELSERVO-J3 series.
Rated output: 0.2kw.
Interface type: CC-Link communication type (built-in positioning function).
Power specification: single phase AC200V.
Positioning operation by setting position and rotational speed data in the positioning table and receiving the start signal from the main controller MITSUBISHI INSTRUCTION MANUAL.
The setting of the position and speed of the positioning table, as well as the start and stop operation can be completed through CC-Link communication.
By using the MR-J3-D01 extension IO unit, the DI/O instruction can be used to select and locate the table.
(CC-Link can not be used for MR-J3-D01 communications).
With built-in positioning function of the servo amplifier, can be set through the CC-Link communications and speed data. (corresponding to the CC-Link version: Ver.1.10)
Can be achieved through the CC-Link communications to start, stop and monitoring and otheer operations MR-J3-200B INSTRUCTION MANUAL.
Serial communication reduce wiring.
Distributed servo control system can be built by CC-Link communication.
The parameters of unit MR-PRU03 (optional) the parameter setting, operation and monitoring more convenient.

The servo amplifier can be used for speed control operation MR-J3-200B Manual.
When the two stations are occupied, the speed can be set directly by the remote register.