1 axis servo amplifier.
MITSUBISHI general AC servo amplifier MELSERVO-J4 series.
Rated output: 0.2kw.
Interface: SSCNET III /H.
Power supply: three phase AC200V or single phase AC200V power supply MR-J2S-700B PDF.
Single phase AC200V is limited to 0.75kW following servo amplifier.
Special specification: full closed loop control 4 wire / device end encoder ABZ phase input corresponding support function security unit, support positioning mode MR-J2S-700B
Servo amplifier supporting SSCNET III /H.
Complete synchronization system capable of using high speed serial optical communication.
Can be combined with the servo system controller to maximize the performance of the servo system MR-J2S-700B PDF.
Not only inherited the original product of high performance and high reliability, but also made a further improvement beyond imagination.
MELSERVO-J4 grand debut.
Servo market for the star of tomorrow. World class servo products.
The new generation of MELSERVO should be what kind of? The answer to this question is already floating
Out of the water MR-J2S-700B PDF. MELSERVO-J4, it represents the whole digital, the original high performance based on an evolutionary.
Is also fully meet the requirementss of human beings and the environment MELSERVO latest masterpiece MITSUBISHI INSTRUCTION MANUAL MR-J2S-700B Manual.
For example, the safety and environmental requirements for the safety of human use and the safety specifications and "to Use Easy" design.
To meet the needs of the environmental protection era of energy-saving performance.
Beyond the performance of the evolution of MELSERVO-J4, shocking debut!Drive: MR-H_ACN series CC-LINK features MITSUBISHI INSTRUCTION MANUAL.
Rated output: 5.0KW.
The test system is composed of two parts, namely, the servo driver, the motor system and the host computer.
The host computer sends the speed command signal to the servo driver,
Servo drives start to run in accordance with the instructions MITSUBISHI INSTRUCTION MANUAL.
In the course of operation, the running data of the servo system is collected by the host computer and the data acquisition circuit,
And carries on the preservation, the analysis and the display to the data. Because the motor is not loaded in this test system,
So compared with the previous two kinds of testing systems, the system has a relatively small volume,
Annd the measurement and control circuit of the system is relatively simple,
But it also makes the system can not simulate the actual operation of the servo drive MR-J2S-700B INSTRUCTION MANUAL.
Usually, such testing system is only used to test the rotational speeed and angular displacement of the tested system under no-load condition,
And can not carry on the comprehensive and accurate test to the servo drive MR-J2S-700B Manual.