MITSUBISHI motor universal AC servo amplifier MELSERVO-J3 series.
Rated output: 22.0kw.
Interface type: SSCNET type III fiber communication.
Full closed loop control MR-J2S-45KB4 PDF.
Power specification: three phase AC200V.
High precision and high response location control.
Full closed loop control can be realized by double feedback control method.
Dual feedback control can be performed between the servo motor encoder and the load side encoder MR-J2S-45KB4
MR-J3-B-RJ006 can be used in conjunction with a number of manufacturers of linear encoder,
Users can build the system according to their own accuracy requirements. ABS type linear encoder using serial interface,
No need to install the battery on the servo amplifier can easily build the absolute position detection system MR-J2S-45KB4 PDF.
Flexible system configuration.
Can achieve higher load side positioning accuracy!The length of the line: 20M.
Relay type.
IP level: IP20.
Bending life: standard MR-J2S-45KB4 PDF.
Encooder with cable (amplifier side); for HF-KP/HF-MP series MR-J2S-45KB4 Manual. MITSUBISHI motor universal AC servo amplifier MELSERVO-J3 series.
Rated output: 7.0kw.
Interface type: CC-Link communication type (built-in positioning function).
Power specification: three phase AC400V.
Positioning operation by setting position and rotational speed data in the positioning table and receiving the start signal from the main controller MITSUBISHI SUPPLEMENTARY INSTRUCTION MANUAL.
The setting of the position and speed of the positioning table, as well as the start and stop operation can be completed through CC-Link communication.
By using the MR-J3-D01 extension IO unit, the DI/O instruction can be used to select and locate the table MITSUBISHI SUPPLEMENTARY INSTRUCTION MANUAL.
(CC-Link can not be used for MR-J3-D01 communications).
With built-in positioning function of the servo amplifier, can be set through the CC-Link communications and speed data. (corresponding to the CC-Link version: Ver MITSUBISHI SUPPLEMENTARY INSTRUCTION MANUAL. 1.10)
Can be achieved through the CC-Link communications to start, stop and monitoring and other operations MR-J2S-45KB4 SUPPLEMENTARY INSTRUCTION MANUAL.
Serial communication reduce wiring.
Distributed servo control system can be built by CC-Link communication.
The parameters of unit MR-PRU03 (optional) the parameter setting, operation and monitoring more convenient.

The servo amplifier can be used for speed control operation MR-J2S-45KB4 Manual.
When the two stations are occupied, the speed can be set directly by the remote register.