Type: general purpose AC servo amplifier MR-E series.
Rated output: 0.1kw.
Interface type: general purpose pulse interface.
KH003 special mark for Super MR-E MR-J2M-BU8 PDF.
High performance and easy to operate, reduce work load.
Enhanced system cost performance.
High performance, high precision positioning (servo motor encoder resolution: 131072).
High response.
Suppression of vibration by adaptive vibration suppression control MR-J2M-BU8
Using personal computer and servo setup software to optimize tuning.
Has 2 types of interfaces:
Position control and speed control with pulse train interface.
The analog input interface is used for speed control and torque control MR-J2M-BU8 PDF. Drive: MR-H_ACN series SSC-NET compatible AC servo.
Rated output: 7.0KW.
The servo controller can easily transfer the operation module and the field bus module through the automation interface,
At the same time using different fieldbus modules to achieve different control modes (RS485, RS232, optical fiber, InterBus, ProfiBus),
And the control mode of general inverter is single MR-J2M-BU8 PDF.
The serrvo controller is directly connected with a rotary transformer or an encoder, which forms a closed loop of speed and displacement control MR-J2M-BU8 Manual.
The general inverter can only form an open loop control system MITSUBISHI INSTRUCTION MANUAL.
Servo controller of the control parameters (such as steady-state accuracy and dynamic performance) is better than the general inverter. 1 axis servo amplifier.
MITSUBISHI general AC servo amplifier MELSERVO-J4 series.
Rated output: 1.0kw.
Interface: SSCNET III /H MITSUBISHI INSTRUCTION MANUAL.
Power supply: three phase AC400V.
0.6kW and 1kW above the servo amplifier.
Servo amplifier supporting SSCNET III /H.
Complete synchronization system capable of using high speed serial optical communication.
Can be combined with the servo system controller to maximize the performance of the servo system MITSUBISHI INSTRUCTION MANUAL.
2 low frequency vibration can be suppressed at the same time by supporting the seismic algorithm of 3 inertial equipment.
Configurator2 MR to achieve convenient adjustment.
Effectively restrain the low frequency aftershock effect produced by the front endd of the boom or the main body of the device 100Hz MR-J2M-BU8 INSTRUCTION MANUAL.
Can effectively shorten the time to control the stability of the aftershock.
In the XY design of trajectory control, improve the accuracy of arc track.
At the same time, it can efffectively control the phenomenon of quadrant protrusion caused by the rotation direction of the servo motor, which is caused by friction and twisting MR-J2M-BU8 Manual.