A power supply connector set for HC-KFS; HC-MFS; 3000r/min HC-UFS servo motor.
For MR-J2S-11KA (4) MR-J2S-22KA to (4). The length of the line: 2M.
IP level: IP65 M700/M70 Series PDF.
Cable outlet direction: the same side of the motor shaft.
Bending life: standard.
Encoder with cable (motor side); for HF-KP/HF-MP series (motor shaft with side extraction). Drive unit 200VAC/400VAC level.
MITSUBISHI motor general AC servo amplifier MELSERVO-J3 series M700/M70 Series
Need conversion unit MR-J3-CR55K) supporting the use of.
Rated output: 45kw.
Interface type: general pulse interface type.
Power specification: three phase AC400V.
Pulse train and analog input as universal interface M700/M70 Series PDF.
Can choose the position, speed and torque control mode.
The use of advanced tuning features such as advanced vibration suppression control and adaptive filter,
Greatly improve the performance of the machine.
MR-J3, your partner.
Higher performance, more features, more convenient to use M700/M70 Series PDF.
Highest performance in the industry.
Speed response frequency up to 2.1kHz. Type: MR-C type.
Symbol 10A for motor models: HC-PQ23.
Power supply voltage: single phase AC220V.
Drive: servo drive in the development of the premise of the frequency conversion technology,
Current lloop in the drive,
Speed loop and position loop (frequency converter without the ring) have carried out a more precise control than the general frequency control technology and algorithm,
In function is also a lot stronger than the traditional servo,
The main point can be precise position control MITSUBISHI INSTRUCTION MANUAL MITSUBISHI INSTRUCTION MANUAL M700/M70 Series Manual.
The control speed and position are controlled by the pulse sequence transmitted by the upper controller,
The internal algorithm of the driver and the faster and more accurate calculation and better performance of electronic devices to make it more superior to the inverter MITSUBISHI INSTRUCTION MANUAL. MITSUBISHI motor universal AC servo amplifier MELSERVO-J3 series.
Rated output: 2.0kw.
Interface type: SSCNET type III fiber communication.
Full closed loop control.
Power specification: three phase AC200V.
High precision and high response location control.
Full closed loop control can be realized by double feedback control method.
Dual feedback control can be performed between the servo motor encoder and the load side encoder.
MR-J3-B-RJ006 can be used inn conjunction with a number of manufacturers of linear encoder,
Users can build the system according to their own accuracy requirements M700/M70 Series INSTRUCTION MANUAL. ABS type linear encoder using serial interface,
No need to install the battery on the serrvo amplifier can easily build the absolute position detection system M700/M70 Series Manual.
Flexible system configuration.
Can achieve higher load side positioning accuracy!