A series of high performance models that are widely used in network or single machine work environments.
Screen size: 5.7 inches.
Display color: 256 color or more color GT2710-VTWD-GF PDF.
Mounting type: panel mounting type.
Resolution: QVGA (320 x 240).
Display device: STN color.
Host frame color: black.
Power type: DC24V.
Communication interface: with built-in RS-422.
Ideal model for high performance in a network or independent operation environment GT2710-VTWD-GF
User storage capacity: 9MB (GT15__-VNB_:5MB).
Device USB port.
Standard RS-232 interface.
Support video /RGB unit.
If the capacitive touch screen is in the middle of the operation, the display resolution or display mode of the touch screen is changed again,
Or the refresh rate of the touch screen controller is adjusted by itself, and the cursor and the touch point can not be felt when the cursor is not corresponding to the touch point,
Must be re calibrated to the touch screen system GT2710-VTWD-GF PDF GT2710-VTWD-GF PDF GT2710-VTWD-GF Manual .
In order to ensure the normal operation of the touch screen system, in addition to ensure the proper installation of the system software,
Must also remember that in a host do not install two or more than two kinds of touch screen driver,
This will cause the system to run in conflict, so that the touch screen system can not be used properly MITSUBISHI MES Interface Function Manual. Cable length: 1.2m.
For QnA/ACPU/ motion controller CPU (A series, extended basis system) and the connection between GOT.
Applicable models: GT16, GT15, GT11. Cable length: 3m.
The connection between the FXCPU (MINI-DIN8 pin connector) and the graphic operation terminal MITSUBISHI MES Interface Function Manual.
Connection between FXCPU communication function extension board (MINI-DIN8 pin connector) and GOT.
Applicable models: GT10, GT21. Cable length: 1m.
The connection between thee FXCPU (MINI-DIN8 pin connector) and the graphic operation terminal GT2710-VTWD-GF MES Interface Function Manual.
Connection between FXCPU communication function extension board (MINI-DIN8 pin connector) and GOT MITSUBISHI MES Interface Function Manual.
The unit can noot be used with FX1NC, FX2NC, FX3UC-D/DSS, FX3G GT2710-VTWD-GF Manual .
Applicable models: GT10, GT21. Oil resistant cap for 3.7 inch screen.
Applicable model: hand held GOT.