Cable length: 20m.
For QnA/ACPU/ motion controller CPU (A Series) /FXCPU. Connection between (D-SUB25 pin connector) and GOT.
For the connection between FA-CNV*CBL and GOT GT2705-VTBD-GF PDF.
Connector for serial communication unit and GOT.
For the connection between AJ65BT-G4-S3 and GOT.
Applicable models: GT16, GT15, GT11, HandyGOT, GT10, GT27, GT25, GT23,, GT21. For video input (NTCS/PAL) 4 channel / RGB input 1 channel composite input GT2705-VTBD-GF
Applicable model: GT15. Cable length: 3m.
Connection conversion box for Q/LCPU and hand held GOT.
Applicable model: GT10. Cable length: 30m.
Connection between serial communication unit and GOT GT2705-VTBD-GF PDF.
Connection between a computer link unit and a GOT.
Applicable models: GT16, GT15, GT11, HandyGOT, GT10, GT27, GT25, GT23,, GT21. Cable length: 3m.
The connection between the CC-LINK interface unit and the smart GOT.
Applicable model: HandyGOT. With 4.3 inch widescreen.
Surface treatment: transparent GT2705-VTBD-GF PDF.
Protective film color: No.
USB protective cover parts: no openings.
Set number: 5.
Applicable model: GT21. Protective film for 15 inch screen.
Scrub, 5.
Applicable model: GT15. Cabble length: 20m GT2705-VTBD-GF Manual .
For the connection between the two graphic operations.
Applicable models: GT16, GT15, GT11 MITSUBISHI User's Manual. A series of high performance models that are widely used in network or single machine work environments.
Screen size: 12.1 inches.
Display color: 256 color or more color.
Mounting type: panel mounting type.
Resolution: SVGA (800 x 600).
Display device: TFT color (high brightness, wide viewing angle) MITSUBISHI User's Manual.
Host frame color: black.
Power type: AC100~240V.
Communication interface: with built-in RS-422.
Ideal model for high performance in a network or independent operation environment.
User storage capacity: 9MB (GT15__-VNB_:5MB).
Device USB port.
Standard RS-232 interface MITSUBISHI User's Manual.
Support video /RGB unit.
If the capacitive touch screen is in the middle of the operation, the display resolution or display mode of the touch screen is changed again,
Or the refresh rate of the touch screen controller is adjusted by itself, and the cursor and the touch point can not be felt when the cursor is not corresponding to the touch point,
Must be re calibrrated to the touch screen system GT2705-VTBD-GF User's Manual.
In order to ensure the normal operation of the touch screen system, in addition to ensure the proper installation of the system software,
Must also remember that in a host do not install two oor more than two kinds of touch screen driver,
This will cause the system to run in conflict, so that the touch screen system can not be used properly GT2705-VTBD-GF Manual .