10.4 inches.
Surface treatment: transparent.
Protective film color: No.
USB protective cover parts: no openings.
Set number: 5.
Applicable model: GT21 GT1030-LBD2 PDF. Cable length: 3.0m.
For QnA/ACPU/ motion controller CPU (A series, extended basis system) and the connection between A7GT-CNB.
Applicable models: GT16, GT15, GT11. Protective film for 3.7 inch screen.
Scrub (frame: white), 5.
Applicable model: GT1020 GT1030-LBD2 Cable length: 1.5m.
For the connection between FXCPU and GOT.
Connection between a power supply and an operating switch and a GOT.
Applicable model: HandyGOT. Protective film for 5.7 inch screen GT1030-LBD2 PDF.
Transparent, 5.
Applicable model: GT15. Cable length: 10m.
The connection between the CC-LINK interface unit and the smart GOT.
Applicable model: HandyGOT. Protective film for 3.7 inch screen.
Transparent (frame: white), 5.
Applicable model: GT1020. Cable length: 10m.
Connection between a connector adapter box and a smart GOT GT1030-LBD2 PDF.
Applicable model: HandyGOT. Protective film for 5.7 inch screen.
Scrub, 5.
Applicable model: GT11. Protective film for 12.1 inch screen.
Transparent (frame: white), 5.
Applicable model: GT15. Protective film for 8.4 inch screen.
Trransparent, 5 GT1030-LBD2 Manual .
Applicable model: GT16 MITSUBISHI Connection Manual. For video input (NTCS/PAL) 4 channels.
Applicable model: GT16. A series of high performance models that are widely used in network or single machine work environments.
Screen size: 12.1 inches.
Display color: 256 color or more color.
Mounting type: panel mounting type.
Resolution: SVGA (800 x 600) MITSUBISHI Connection Manual.
Display device: TFT color (high brightness, wide viewing angle).
Host frame color: black.
Power type: DC24V.
Communication interface: with built-in RS-422.
Ideal model for high performance in a network or independent operation environment.
User storage capacity: 9MB (GT15__-VNB_:5MB).
Device USB port MITSUBISHI Connection Manual.
Standard RS-232 interface.
Support video /RGB unit.
If the capacitive touch screen is in the middle of the operation, the display resolution or display mode of the touch screen is changed again,
Or the refresh rate of the touch screen controller is adjusted by itself, and the cursor and the touch point can not be felt when the cursor is not corresponding to the touch point,
Must be re callibrated to the touch screen system GT1030-LBD2 Connection Manual.
In order to ensure the normal operation of the touch screen system, in addition to ensure the proper installation of the system software,
Must also remember that in a host do not install two oor more than two kinds of touch screen driver,
This will cause the system to run in conflict, so that the touch screen system can not be used properly GT1030-LBD2 Manual .