Connecting cable for handheld GOT and PLC.
Cable length: 3 meters.
Application: RS-422 connection. Power: 5.5kw.
Purpose: high frequency braking resistor FX3G-485-BD PDF.
The use rate of the built-in regenerative brake of the transducer can be promoted.
When using the FR-ABR type brake resistor, the short circuit piece between the terminal PR-PX is removed. Does not remove the short circuit chip will lead to overheating of the brake resistor FX3G-485-BD
The utilization rate of the regenerative braking should be less than the allowable brake use rate in the above table.
With the operating frequency of the brake resistor to reach 300 degrees C or higher, it is necessary to take protective measures and cooling FX3G-485-BD PDF.
MYS type resistor can be used. But please pay attention to the allowable brake use rate FX3G-485-BD Manual.
Do not remove the terminal P/+ and P1 between the short circuit chip, in addition to connecting the DC reactor.
The installation of thermal relay, to avoid overheating and burn the braking resistor FX3G-485-BD PDF. Function: CPU module (internal service power supply).
Input and output points: 80 points.
Power supply capacity (DC5V power): 1100mA.
Power supply capacity (DC24V service power supply): 600mA.
Input / output mode: DC input (drain / source) / transistor (source) MITSUBISHI INSTALLATION MANUAL.
Input points: 40 points.
Output points: 40 points.
The new expansion module is more convenient!
Pioneer products with advanced built-in functions and rich extensibility.
FX5U built-in analog, communication, high speed input and output,
By extending the board and adapter can be easily extended system MITSUBISHI INSTALLATION MANUAL.
In addition, through the high speed system bus,
Can maximize the role of the built-in intelligent functions of the expansion device.
Protocol: SLMP, TCP/IP, UDP.
Communication mode: full duplex / half duplex.
At the same time can open a few: 4 coonnection MITSUBISHI INSTALLATION MANUAL FX3G-485-BD INSTALLATION MANUAL.
Weight: 0.3kg.
Connect PLC FX3U/FX3UC to Ethernet.
Support fixed buffer storage, communication connection MELSOFT, through the MC communication protocol, e-mail messages.
When connected tto the MELSOFT, through the Works2 PLC can achieve the remote maintenance of GX program FX3G-485-BD Manual.
Connecting FX3UC, FX3GC requires FX2NC-CNV-IF or FX3UC-IPS-5V.