MITSUBISHI inverter FR-E720 series.
Voltage level: 3 phase 200V.
Frequency converter capacity: 7.5KW.
In order to ensure the reliability of production, all production machinery in the design of power with drive, there is a certain amount of surplus FR-V540-3.7K-CH PDF.
When the motor can not run under full load, in addition to meet the requirements of power driven,
The surplus torque increases the active power consumption, resulting in the waste of electric energy FR-V540-3.7K-CH
Speed control method of fan and pump equipment traditional by regulating the entrance or exit of the baffle, valve opening to regulate air flow and water flow
, the input power is large, and a large amount of energy consumption in the baffle, the valve in the process of closure FR-V540-3.7K-CH PDF.
When ussing variable frequency control, if the flow rate is reduced, the speed of the pump or fan can be reduced to meet the requirements FR-V540-3.7K-CH Manual. Max input / output points: 30 points FR-V540-3.7K-CH PDF.
Supply voltage: 100 - 240VAC.
Input points: 16 points.
Output points: 14 points.
Output type: Transistor (source).
Power consumption (W): 21.
Weight (kg):0.45.
Size (WxHxD) mm:100x90x75.
All equipment is digital input and output point.
The total I/O points are not more than 30 points, and the input points are less than 16, the output points are less than 14 MITSUBISHI INSTRUCTION MANUAL.
Its MT series of PLC can drive 2 way servo or stepper, commonly used in the control system for a simple manipulator.
MITSUBISHI FX1S series PLC is suitable for the smallest package,
It is the preferred target for low cost users to seek powerful control over a limited range of I/0 MITSUBISHI INSTRUCTION MANUAL.
FX1S provides up to 30 I/O points, and can be transmitted through serial communication data,
MT models also have the ability to locate, widely used in a variety of small mechanical equipment. Display: 7 segment digital display + iicon display MITSUBISHI INSTRUCTION MANUAL FR-V540-3.7K-CH INSTRUCTION MANUAL.
Can monitor, change the value of software components.
Can also be simple to operate, change the value.
Equipped with a button operation can be used (operator certification function)) and control through the PLC control function,
Can be used with the function expansion board FR-V540-3.7K-CH Manual.
Can be installed directly to the FX3S, FX3SA, no wiring.