Connecting cable for handheld RH GOT and PLC.
Cable length: 10 meters.
Application: RS-422 connection and RS-232C connection. MITSUBISHI inverter series: FR-F840 FR-E740-0.75K-CHT PDF.
Voltage level: three phase 400V.
Power: 15.0kw.
SLD converter rated current: 31.0A.
Structure and function: Standard model.
Type: CA.
Substrate coating: have.
2 times the power consumption of the wind turbine and pump and the speed of the 3 power consumption is proportional to the speed of the rotating speed FR-E740-0.75K-CHT
Through the speed control of the frequency converter to adjust the air flow, can reduce the power consumption.
Give full play to the performance of the motor FR-E740-0.75K-CHT PDF.
The excitation current is always adjusted to the best state, which can improve the efficiency of the motor.
Load torque is smaller, can further improve energy efficiency.
For example, when a general motor is used, the optimal excitation control mode in the 4% motor load torque is about 30% more than that of the V/F control FR-E740-0.75K-CHT PDF. Max input / output points: 64 points.
Supply voltage: 100 - 240VAC.
Input points: 32 points.
Output points: 32 points.
Output type: relay.
Power consumption: 60VA.
Weight (kg):1.0.
Size (WxHxD) mm:220x90x87.
Note recording function, Component annotation can be recorded in the program register MITSUBISHI Instruction manual.
Online program editor, online change the program will not lose the working hours or stop production operation.
RUN/STOP switch, running on panel / stop switch easy to operate.
Remote maintenance, remote programming software can monitor, upload or uninstall programs and data via modeem communications
Password protection, using a eight digit password to protect your program MITSUBISHI Instruction manual FR-E740-0.75K-CHT Manual .
Clock function and hour meter function, all of the PLC FX2N has a real-time clock standard.
Continuous scanning function, to define the operation cycle for the application of the continuous scan time MITSUBISHI Instruction manual.
Input filter adjustment function, you can use the input filter to smooth the input signal (in the basic unit x000 to x017). Total input and output points: 16 points.
Output points: 16 points.
Output type: transistor output.
FX2N extension module.
The expansion module is an input and output expansion device of the power supply from the basic unit or the expansion unit,
Can choose the relay or crystal output models, to 8 points for the unit to connect.
Can be extended to FX3GA/FX3G, FX3GE, FX3GC, as well as FX3U, FX3UC series,
When connecting to FX3UC or FX3GC, you need FX2NC-CNV-IF or FX3UC-1PS-5V.
The number of connection points depends on the basic unit and the expansion unit.
FX Series in the compact body built in superior performance, and strive to operate simmple FR-E740-0.75K-CHT Instruction manual.
In addition, rich options can meet the various needs of customers.
In the virtual factory will be rich in the function of a part of the introduction.
It is easy to control the analog quantity of the application.
Can bbe extended to all models in the FX series analog devices FR-E740-0.75K-CHT Manual .
Function extension board, special adapter without programming can be used for communication.