Specifications: HPP mainframe, cable.Analog input: 2.
Analog output points: 1 points.
Weight: 0.1kg.
FX3 series can be connected to the 2 channel input (voltage: DC0~10V, or current DC4~20mA), as well as 1 channel output (DC0~10V, or current: DC4~20mA) of the adapter FR-A740-3.7K-CHT PDF.
Each channel can be specified as a current input or voltage input.
Connecting FX3SA, FX3S, FX3GA, FX3G, and FX3U main body, the need to convert the adapter or function expansion board FR-A740-3.7K-CHT MITSUBISHI inverter FR-D740 series.
Voltage level: three phase 400V.
Frequency converter capacity: 5.5KW.
The internal and back of the inverter structure considering the cooling effect, the relationship between the upper and lower ventilation is also important,
Therefore, in orderr for the type of unit, hanging on the wall to the vertical position, the installation of vertical as possible FR-A740-3 FR-A740-3.7K-CHT Manual . 7K-CHT PDF.
Transducer can be used to drive a single phase motor? Can single phase power supply be used?
Basically can not be used FR-A740-3.7K-CHT PDF. For a single phase motor with governor switch, the auxiliary winding will be burnt when the speed is below the operating point;
For the capacitor start or capacitor operation mode, the capacitor explosion will be induced MITSUBISHI TECHNICAL MANUAL.
The inverter power supply is usually 3, but the capacity for small, single-phase power is also useful functioning aircraft. Convert connector to screw relay terminal.
The action of the signal of the conversion module is shown in the light of the lamp.
Negative common end with display. "Power: 55kw MITSUBISHI TECHNICAL MANUAL.
Voltage: 400V.
Brake resistor, a kind of ripple resistance, is mainly used in the mechanical system of the inverter to control the speed of the motor,
Help the motor to be converted into heat energy due to the regenerative power of the motor.
Braking unit principle: the bbrake unit is composed of a high power transistor GTR and its driving circuit MITSUBISHI TECHNICAL MANUAL FR-A740-3.7K-CHT TECHNICAL MANUAL.
Its function is to link the discharge current braking resistor capacitor voltage or not in the range of the time connsumed and the DC part "overpressure",
Need to add external braking components, in order to speed up the speed of the consumption of renewable energy FR-A740-3.7K-CHT Manual . "