RS-485 communication. Special communication adapter.Input points: 8 points.
Output points: 6 points.
Power supply voltage: AC100-240V.
Output type: transistor output (source) FR-A740-280K-CHT PDF.
Built in CPU, power supply, input and output. While maintaining the convenience of FX1N while improving performance.
Special adaptor and function expansion board can be installed and used FX3 series.
High speed operation FR-A740-280K-CHT
Basic instructions: 0.21 s/ instruction.
Application instruction: 0.5 s/ instruction.
Large capacity memory.
Built in program memory 32000 steps.
EEPROM memory cartridge with program transfer function FR-A740-280K-CHT PDF. Power: 15kw.
Voltage: 200V.
The surge voltage of the motor can be suppressed when the 400V motor is driven by a frequency converter.
Mottor suitable for 5 FR-A740-280K-CHT Manual. 5 to 37kW. Power: 7.5kw.
Purpose: to suppress the power harmonics.
Improve the power factor, reduce the input side of the high harmonic current FR-A740-280K-CHT PDF.
Make sure that this option is installed in the FR-A820-03800 (75K) and FR-A840-02160 (75K) and above capacity and above capacity.
At the same time the installation options in the use of 75kW and above motor. (the IP55 series has a built-in DC reactor.)
According to the motor power used to select the DC reactor MITSUBISHI PLC FUNCTION PROGRAMMING MANUAL.
(when the inverter capacity is greater than the motor capacity, is still based on the motor capacity to choose.) Convert connector to screw relay terminal.
The action of the signal of the conversion module is shown in the light of the lamp.
Negative common end with display. The number of output channels: 4 channels MITSUBISHI PLC FUNCTION PROGRAMMING MANUAL.
Voltage output: DC-10~10V.
Current output: DC0~20mA, DC-4~20mA.
Programmable logic controller: FX2NC, FX3UC.
By using analog input module and output module,
Can be input and output analog (voltage, current, etc.).
Indispennsable analog control in FA control,
It is easy to implement on a programmable logic controller MITSUBISHI PLC FUNCTION PROGRAMMING MANUAL FR-A740-280K-CHT PLC FUNCTION PROGRAMMING MANUAL. Power: 75kw.
Voltage: 200V.
The power factor of the input power factor is up to 0.999 and above (100% load) FR-A740-280K-CHT Manual.
Can be connected to multiple inverters, to achieve a common DC bus mode.
Equipped with standard power retrogradation function.