The connector is converted to a screw relay terminal.Length: 55mm.
Function: connect GM-FX.
Corresponding models: FX2N-10GM, FX2N-20GM. Power: 2.2kw.
Purpose: high frequency braking resistor FR-A720-15K PDF.
The use rate of the built-in regenerative brake of the transducer can be promoted.
When using the FR-ABR type brake resistor, the short circuit piece between the terminal PR-PX is removed. Does not remove the short circuit chip will lead to overheating of the brake resistor FR-A720-15K
The utilization rate of the regenerative braking should be less than the allowable brake use rate in the above table.
With the operating frequency of the brake resistor to reach 300 degreess C or higher, it is necessary to take protective measures and cooling FR-A720-15K PDF FR-A720-15K Manual .
MYS type resistor can be used. But please pay attention to the allowable brake use rate.
Do not remove the terminal P/+ and P1 between the short circuit chip, in addition to connecting the DC reactor FR-A720-15K PDF.
The installation of thermal relay, to avoid overheating and burn the braking resistor. "MITSUBISHI inverter FR-F740 series.
Voltage level: three phase 400V.
Frequency converter capacity: 1.5KW.
The use of frequency converter motor is in order to speed, and reduce the starting current MITSUBISHI TECHNICAL MANUAL.
In order to produce a variable voltage and frequency, the device is the first power of the AC power conversion to DC (DC), the process is called rectification.
The direct current (DC) is transformed into alternating current (AC) and its scientific term is "inverter" (inverter) MITSUBISHI TECHNICAL MANUAL.
General inverter is the DC power supply inverter for a certain fixed frequency and a certain voltage of the inverter.
For the inverter as the frequency adjustable, adjustable voltage inverter, we called the inverter FR-A720-15K TECHNICAL MANUAL. "Power: 560kw.
Voltage: 400V.
The power factor of the input power factor is up to 0 MITSUBISHI TECHNICAL MANUAL. 99 and above (100% load).
Can be connected to multiple inverters, to achieve a common DC buus mode FR-A720-15K Manual .
Equipped with standard power retrogradation function. Cable flat cable;
Connector with 20 pin installed at both ends of the fuse.
Length 1.5M.