Output type: transistor output, drain type.
Output points: 16 points.
OFF leakage current: 0.1mA.
Output protection function.
Rated load voltage / current: DC24V/DC24V/0 A0J2E-E56DS PDF. 1A.
External connection: 2 wire.
Sensor connector type (E-CON type).
Using industry standard E-CON type.
Simple wiring through sensor connector.
When installing the module can choose to use the DIN guide rail or screw mounting A0J2E-E56DS
3 wire sensor input. There are many A6TB models to different types of matching with the I/O module.
The cable can be connected to the I/O module of 32 points or 64 points by using the terminal row of the wire in advance A0J2E-E56DS PDF.
These cables have a variety of lengths to be selected, so that
Using the module wiring and terminal is not only connected with the connector. A1SG60 is an empty cover that is used to plug in the unused I/O slot on the main board or on the extended board. A0J2E-E56DS Manual.
A1SG60 is a reserved dummy module I/O point to PLC extended I/O system A0J2E-E56DS PDF.
With the switch on the module can be set to retain the I/O point,
Can set 16 points, 32 points, 48 points and 64 points. MITSUBISHI PLC hardware implementation
Hardware implementation is mainly for the control cabinet and other hardware design and field construction MITSUBISHI User's Manual.
Design control cabinet and the operating table and other parts of the electrical wiring diagram and wiring diagram.
Electrical interconnection diagram of each part of the design system.
According to the construction drawings of the site wiring, and carry out a detailed inspection MITSUBISHI User's Manual.
Because the program design and hardware implementation can be carried out at the same time,
So the design cycle of the MITSUBISHI PLC control system can be greatly reduced. Output type: transistor output, drain type.
Output points: 16 points.
OFF leakage current: 0.1mA.
Output protection function: No MITSUBISHI User's Manual.
Rated load voltage / current: DC12V/DC24V/0.5A.
External connection: 2 wire.
Spring clip terminal.
DDo not need to be tightened further or locked with screws, which can reduce the working hours of wiring A0J2E-E56DS User's Manual.
Using 2 pieces of structure of the terminal units, maintenance can be maintained in the same line under the condition of the replacement module A0J2E-E56DS Manual.
When installing the module can choose to use the DIN guide rail or screw mounting.
Can be used for the 3 wire sensor input wiring.